Mercedes Sprinter Van Meyle Engine Water Pump
This product is compatible with all Sprinter Vans made after 2007. This includes both the 2500 and the 3500 versions.
Please note that this item only ships free to the Contiguous United States. It does not include Canada, Hawaii, Alaska, or the other USA territories.
What is this thing?
This is a water pump. Water pumps keep your engine from overheating.
What’s the warranty for this part?
The warranty for this water pump is 24 months or 24k miles.
Why should I get a new one?
If a water pump is failing then it will cause an engine to overheat. The damage to your engine could be serious if your water pump fails.
When should I replace my water pump?
Water pumps can handle on average 450,000 gallons of coolant in around 4 years (or 62,000 miles). We recommend checking the water pump at each service interval. Gates Waterpumps recommends changing water pumps whenever belt kits are fitted & recommends the replacement of old gaskets & seals with new ones.
I changed my belt kit but not my water pump… am I gonna be alright?
No! We recommend changing the two out at the same exact time. A decision to change the belt now, but not to replace the water pump at the same time, assumes that the water pump will last for another complete duty cycle of the belt.
Can you tell me how to install a new water pump?
**Always wait until the engine is cool before working on any part of the cooling system.**
Remove the belt drive components following the vehicle manufacturer’s recommended procedures.
Be aware that a considerable amount of coolant can pour out of the hose when you take it off. Remove the hose attached to the water pump.
Remove the old water pump by Loosening the bolts.
Remove the old seal/gasket or old sealant remains & make sure the mounting surface is clean.
Inspect the other cooling system service parts: coolant hoses, thermostat and pressure cap(s) before installing the new water pump.
Do not force the pump on by striking the pump shaft while installing the new water pump. Carefully follow the installation instructions.
Old gaskets & seals should be replaced by new ones. Put an even bead of sealant along the edge of the part, but don’t use too much sealant. Only apply sealant if specifically recommended by the vehicle manufacturer. Too much sealant compromises the correct installation and will break off within the cooling system, contaminating it. If you do get too much sealant on the part, wipe off the excess before mounting the new water pump. Sealants are also made with different drying rates, so follow the sealant’s printed instructions.
Tighten the bolts evenly to the manufacturer’s torque specifications.
Carefully re-attach the hose.
Manually rotate the pump & make sure it rotates freely.
The belt drive system works hand in hand with the water pump.
According to Gates changing the water pump, belt & other drive components at the same time is good preventive maintenance practice. Make sure the belt drive system that will drive the new water pump is in perfect condition and installed following the vehicle manufacturer’s recommended procedures.
Keep in mind that some leaks will become obvious when the engine is cold, but others only when it is hot.
Visually inspection to ensure there are no leaks after the cooling system refill.
When a water pump is new, some seepage from the weep hole is normal as it takes about ten minutes of operation for the pump’s internal mechanical seal to properly seat itself (break-in period). More pronounced seepage and drips from the weep hole after this break-in period or leakage from the mounting surface are abnormal and signal part failure or faulty installation.
OEM Code: 6422002201
Meyle Code: 013 220 0013
We use Begel, genuine Mercedes Benz, and other top quality name brand parts that carry warranties. We may substitute your part with a possible better quality option if we need to.
Not confirmed to fit 2019 models as of yet. We are currently researching what parts will fit the 2019 models of Sprinter vans.